This yellowish-green gas crystallizes as bright orange crystals at -59 °C. As one of several oxides of chlorine, it is a potent and useful oxidizing agent used in water treatment and in bleaching.
 
Health Effects:At gas-phase concentrations greater than 30% volume in air at STP (more correctly: at partial pressures above 10 kPa), ClO2 may explosively decompose into chlorine and oxygen. The decomposition can be initiated by, for example, light, hot spots, chemical reaction, or pressure shock. Thus, chlorine dioxide gas is never handled in concentrated form, but is almost always handled as a dissolved gas in water in a concentration range of 0.5 to 10 grams per liter. Its solubility increases at lower temperatures, thus it is common to use chilled water (5 °C, or 41 °F) when storing at concentrations above 3 grams per liter. In many countries, such as the USA, chlorine dioxide gas may not be transported at any concentration and is almost always produced at the application site using a chlorine dioxide generator. In some countries, chlorine dioxide solutions below 3 grams per liter in concentration may be transported by land, however, they are relatively unstable and deteriorate quickly.
Short Term Exposure Limit (STEL) – 0.3 PPM
Time Weighted Average (TWA) – 0.1 PPM
Immediately Dangerous to Life or Health (IDLH) – N/A
Lower Explosive Limit (LEL) – N/A
CAS # - 10049-04-4
The Products:

    POLI MP400 / MP400P

    Read more about POLI MP400 / MP400P The POLI multi-gas detectors offer up to 6 gas monitoring of toxic gases, Oxygen (O2), Combustibles (LEL), Carbon Dioxide (CO2) and Volatile Organic Compounds (VOCs)... Read More


    UNI MP100

    Read more about UNI MP100 The UNI MP100 offers simple, personal protection for a wide array of toxic gas and Oxygen (O2) measurement applications. In addition to common sensors such as Carbon Monoxide (CO), Hydrogen Sulfide (H2S), Nitrogen Dioxide (NO2), Ammonia (NH3) and Sulfur Dioxide (SO2)... Read More


    iBrid MX6

    Read more about iBrid MX6 The display improves safety with clear readings in low-light, brightlight or anywhere in between. Whether the work is outside, inside or underground, it’s easy to see what gas hazards lurk... Read More


    GasBadge Pro

    Read more about GasBadge Pro Featuring interchangeable “smart” sensors, these enable the GasBadge Pro to quickly adapt to monitor unsafe levels of Oxygen or any one of the following toxic gases... Read More


    BW Solo

    Read more about BW Solo BW™ Solo is an easy to service single-gas detector with BLE connectivity that provides real-time visibility into the status and safety of hazardous-area workers...... Read More


    D-Guard²

    Read more about D-Guard² D-Guard² offers world leading 2-wire loop powered NDIR methane and carbon dioxide monitoring capability, allowing greater numbers of detectors to be driven from smaller power supplies, reduced cable diameters... Read More


    D-Guard²R

    Read more about D-Guard²R D-Guard²R comes standard with a built in relay board. This includes 3 relays; 2 for the low and high alarms set within the transmitter and a third for fault. ... Read More


    Gastec Colourmetric Tubes

    Read more about Gastec Colourmetric Tubes Standard detector tubes are thin glass tubes with calibration scales printed from which you can directly read concentrations of the substances (gases and vapours) to be measured.... Read More


    GasAlert Extreme (Discontinued)

    Read more about GasAlert Extreme (Discontinued) Designed with durability and comfort in mind, the GasAlert Extreme reliably monitors for any single gas hazard within its wide range of available toxic gas models. With easy on/off operation, this single gas detector offers extended ... Read More


    ToxiPRO (Discontinued)

    Read more about ToxiPRO (Discontinued) You should never compromise on safety. The new improved ToxiPro has three visual alarm windows for increased worker safety. Even better, each alarm window comes standard with both high visibility yellow and red alarm LEDs. ... Read More


    ToxiRAE Pro

    Read more about ToxiRAE Pro The ToxiRAE Pro can detect a broad range of gases - from carbon monoxide, hydrogen sulfide, and oxygen to ammonia, chlorine, and formaldehyde. The ToxiRAE Pro provides safety professionals wireless remote access... Read More


    MultiRAE Pro

    Read more about MultiRAE Pro The MultiRAE Pro is the industry’s only portable wireless multi-threat monitor. The MultiRAE Pro’s ability to simultaneously detect gamma radiation and toxic industrial chemicals (TICs/TIMs) enables responders to reduce ... Read More


    MultiRAE Lite

    Read more about MultiRAE Lite The MultiRAE Lite is the optimal one-to-six1-gas monitor for personal protection and leak detection applications. The MultiRAE Lite is available in pumped and diffusion versions and features... Read More


    MultiRAE

    Read more about MultiRAE The MultiRAE is the most advanced portable chemical detector on the market. The MultiRAE delivers the broadest PID sensor range in its class and the versatility to support 25 intelligent interchangeable sensor options... Read More


    GasAlertMicro5 Series (Discontinued)

    Read more about GasAlertMicro5 Series (Discontinued) Simultaneously monitor and display up to five atmospheric hazards with the GasAlertMicro 5. Adaptable to a variety of applications, the GasAlertMicro 5 has an extensive selection of user-settable field options ... Read More


    Eagle (Discontinued)

    Read more about Eagle (Discontinued) The EAGLE is a powerful instrument that does more than just offer the standard confined space protection for LEL, O2, H2S and CO. Detection combinations never before offered in a portable gas monitor are now available featuring... Read More


    Sample Draw Transmitter (Discontinued)

    Read more about Sample Draw Transmitter (Discontinued) The Sample-Draw Transmitter is a single gas detector, which allows users to extract a gas sample from deep shafts, tall ceilings, wells, pits and many other locations where it is either, difficult... Read More