Skip to main contentSkip to footer

Workplace Exposure Limits (WEL)

Australia’s workplace exposure limits are changing on 1 December 2026. Find out what the changes mean for your gas detection equipment and how Gastech can help.

WES to WEL: what you need to know

From 1 December 2026, Safe Work Australia’s Workplace Exposure Limits (WEL) replace the old Workplace Exposure Standards (WES). There’s still a lot of uncertainty out there, so this page covers what’s changing, what it means for your gas detectors, and what we’re doing at Gastech.

What’s changing
Not all limits are changing. Many stay the same, while others are now lower, a few are higher, and some gases have limits for the first time.

Nine substances were originally meant to get tighter limits, but these were put on hold. Most will stay at their current levels for now, including some of the most common gases you’ll monitor for: hydrogen sulphide (H₂S), chlorine (Cl₂), hydrogen cyanide (HCN) and nitrogen dioxide (NO₂). The lower limit for benzene has since been confirmed and takes effect on 1 June 2027.

Some dates also vary by state. In WA, the new limit for phosphine has been pushed back to 1 December 2029, and diesel particulate matter won’t change until a further review is done. Victoria has delayed several substances until 2029. If you work across states, check the rules in each one.

Who sets your alarm levels?
You do. Meeting the WEL is a requirement on the workplace, not the equipment. Under WHS law, the business running the site decides what alarm levels suit its workplace. That decision should come from your own risk assessment, ideally with input from an occupational hygienist.

It’s worth checking:

  • Has your risk assessment been updated for the new limits?
  • Are your detectors set to alarm at the right levels for your site?
  • Do your workers do shifts longer than 8 hours? Longer shifts can lower the limit that applies.
  • Can your detectors read down to the new, lower limits?

What we’re doing
From 1 December, new detectors we configure will ship with Gastech’s default alarm levels, worked out from the new limits using a method reviewed by an independent certified occupational hygienist. They form part of our Terms and Conditions of Sale. Detectors shipped directly from the manufacturer keep the manufacturer’s factory settings.

If you need different levels, let us know in writing when you order and we’ll set them up. An admin charge applies. Detectors sent in for service keep their existing alarm levels unless you ask us to change them.

To make it easier to see which detectors suit the new limits, look for the WEL Compliant badge on our product pages. Each product’s WEL tab shows which gases it can measure down to the new limits.

WEL Compliant BADGE

How we can help

Hire
Need gas detection equipment for a site assessment, or something to cover you while you review? We can hire it to you.

New detectors
Looking at new gear? We’ll help you find detectors that suit the new limits.

Change your alarm levels
Once you know the levels you need, we’ll set your detectors up to match. Send them in to us, or book a field service and we’ll come to you.

Got a large fleet? Depending on your setup, some detector software lets you update alarm levels across all your units at once. If you bought your detectors from us, we’ll help you use it to get it done quickly.

Resources

Not sure where to start?
Our team can talk you through your options.

Or call us on +61 8 6108 0000 or email [email protected].

Information as at 20 November 2026. This page is general information only. It doesn’t replace your own risk assessment or advice from a qualified occupational hygienist.

Trusted by

Contact Us

Our experts are here to help with all your gas detector manufacturer and supply needs. Fill out the form and we’ll get back to you as soon as possible.